Furnace Repair in Village of Lakewood, IL
- Last Updated: October 30, 2026
Proudly Serving All of Wisconsin and Illinois
- Family Owned & Operated
- 100% Satisfaction Guaranteed
- 50+ Years Experience
- NATE Certified Technicians
Proudly Serving All of Wisconsin and Illinois
When you need furnace repair in Village of Lakewood, IL, WeatherWise Heating & Cooling, Inc is just down the road in Crystal Lake. Our NATE-certified technicians work in Lakewood homes regularly, and we know that safety comes first when a gas furnace starts acting strange.
Many homes here were built in the 1990s and 2000s, and the gas valves, burners, and connectors in their furnaces have been working for a long time. When those parts wear, the warning signs can be easy to miss.
Lakewood’s wooded lots and long winters keep furnaces working hard from November through March. The more a furnace runs, the faster its gas valve, igniter, and burners wear.
Here are the signs that call for a closer look.
If the gas smell is strong, leave your home and call your gas utility right away.
The gas valve controls when and how much fuel reaches the burners. As it ages, it can stick open or closed, causing heat that starts and stops without warning. A valve that doesn’t fully open can also lead to weak flames and long heating cycles.
Burners collect dust and rust over the years, which changes how the flame burns. A healthy flame is blue and steady. Yellow, lazy flames can mean incomplete combustion, which produces soot and carbon monoxide.
The flexible gas connector and fittings leading to the furnace can loosen or wear too. Small leaks there may not be obvious without testing, which is why we check them on every visit.
Many Lakewood homes also have other gas appliances near the furnace, like a water heater or gas dryer. Every connection adds a point where gas can leak or venting can go wrong, so we check the full area, not just the furnace.
Snow and ice add one more concern. A buried gas meter or vent can cause pressure problems or blocked exhaust, so keeping both clear after a storm is a good habit.
Reach out and let us know what’s happening, especially if you’ve noticed any odor. For no-heat calls in freezing weather, emergency service is available.
Your technician tests for gas leaks around the furnace, checks gas pressure at the valve, and inspects the burners and flame. We test ignition, safety switches, venting, and carbon monoxide levels near the furnace.
We’ll tell you exactly what we found and what needs to happen. Once you approve the repair, we complete it and test the system so you know it’s running safely.
If we find a gas leak, we’ll shut off gas to the furnace and explain what happens next. Your safety always comes before getting the heat back on.
Nancy in Turnberry called because her heat kept coming and going. Some cycles ran normally, while others stopped after a minute with the blower still running.
Our technician watched several cycles and saw the gas valve dropping out partway through. Testing confirmed the valve was failing. He replaced it, checked the gas pressure and connector, and cleaned the burners for a steady flame. Nancy’s heat ran smoothly from then on.
Our technician also checked her CO alarms and recommended replacing one that had reached the end of its life.
We take safety and comfort seriously in every home.
Call WeatherWise Heating & Cooling, Inc whenever your furnace needs attention.
Leave the house and call your gas utility from outside. Call us once it’s safe.
A healthy flame is mostly blue and steady.
A failing gas valve, flame sensor, or limit switch can cause on-and-off heating.
Yes. Loose fittings or worn connectors can leak, which is why testing matters.
Yes. We’re located nearby in Crystal Lake and serve all of Lakewood.